Publix. You take it for granted, but most times it is an all day affair for us to get groceries. We learn to buy smarter, to last longer between runs, and lighter as we have to carry everything on our back, bikes etc.

“Siri, where are the local grocery stores” is an often used phrase on the iPad. She is awesome for that. With all the stores mapped as I am navigating the waterway I can see how close we can get by boat, and then how much closer by dinghy. Can we get close enough to a dock to bike? Can we coordinate it with a Goose run? Is it near somewhere we can anchor for the night? (This gets double points and noted in the log for next trip!)

Coming into Savannah, Ga from the south, with milk running low, we found we could detour just a few miles (half hour by boat) up a navigable creek to Hogan’s Marina that had a Publix next door! I called them on the phone and was told a $10 temporary docking fee would allow us on the dock for a couple of hours. Cool! I don’t have to drop the dinghy, find a place to dock it, and pull it back up…

They were super nice at the marina. We did our grocery run, full heavy duty backpacks, an insulated carry bag for cold stuff, and a couple of other bags, and while Shelly put everything away (including fudge bars!) – we got out the hose, rinsed the boat, filled the tanks, and filled our containers for doing laundry.

Then we were out in the creek and headed for the waterway again.

The day was absolutely beautiful. Sunny, but breezy enough to keep us cool and put up a sail. We had plenty of time to get to Beaufort on Friday and pondering how much farther to go that afternoon.

Then wham!  Once we got back out into the Wilmington River, all of a sudden there was washing machine noise from the engine. Man I hate that! “Shut it down!”

Then you start the process. Do we have room to maneuver or are we in danger of hitting something? We were in 40 feet of water which is a little too deep too anchor comfortably, so we drifted into shallower water with  the wind and tide and dropped an anchor to figure out what was going on.

With the anchor down, and out of trouble, it did not take long to figure out the noise is in the transmission. Oh crap. Is it the 30 year old transmission ($2000 rebuilt) or is it the damper plate which was just replaced in Myrtle Beach last June?

We decided to sail back into the creek to calmer water, let the engine cool down a bit and see.

An hour later, and four tacks back and forth against wind and tide, and we squeaked by the docks on the point and dropped an anchor by a marina.

30 minutes later I had the transmission off and could see the new damper plate had thrown two springs, which should never have happened. On one hand there is joy it is not the tranny, but on the other there is confusion why the damper plate has failed.

For those interested in mechanic stuff, here is where I have dropped the transmission off and can see the broken springs on the damper plate.

Since it is already 330, it is quick to the phones to find a replacement and get it overnighted (only $100 fedex!) so,we can get it fixed and on our way again.

We took Goose into the marina for his walk, and  are very surprised to find we were the talk of the marina! Everyone wants to know why we are anchored, what’s wrong and how can they help. They offered us very reasonable dockage, so we used the dinghy to push Yume into a slip.

Two days later, the engine is fixed, and while we were on a dock ( first time since Dec), we took the opportunity to work on the freezer, rebuild part of the rubrail, pull the dinghy on the dock and scrub the bottom, and give Yume a good wash down.

 

See my fancy teak splicing in the rubrail?  (You are looking over the side of the boat at the protective rail that is mounted on each side of the hull.)

Those are called scarfs by the way. That was a day and a half project to remove the old cracked teak, cut the two new pieces to fit, line up the old screw holes and drill them out, then install with epoxy. Then sanding the pieces together, bung the holes, and sand those, then sand the rest of the rubrail and apply two coats of oil. Cut and install the used piece of stainless rub strip and we are good to go! That bad piece has bothered me since we bought the boat! All fixed and handsome now!

Now for the engine repairs details (those not interested are given permission to skip this part!)

From the last time I did this, I have an eyebolt mounted under the cockpit aluminum plate holding the steering column and just hook a small chain fall that I use to pick up the back of the engine. I have to take off the two rear engine mounts as they are attached to the bell housing which comes off.

The new plate arrived at 10am. Amazing what Fedex will do for $100!

The old damper plate still mounted on the flywheel. This thing is supposed to take up any torsion between the engine flywheel and the transmission. The trans shaft slides into the spline in the middle.

And the new plate is in and ready for the bell housing, engine mounts, and transmission. Really the hardest part of all this is alighting the transmission coupling with the shaft coupling. That is a pain in the butt!
You can just see my makeshift oil pan under the engine. It is a gallon oil container cut in half and works great!

This morning Ryan was supposed to be in charge of getting the dinghy out on the dock and scrubbed. He had notice from me the day before this job was coming, to try and reduce the amount of whining about having to ‘work’ but it didn’t seem to make any difference at all.

If you are a parent , you might identify with the thought of “it’s just easier to do it myself that’s listen to all this whining” but you decide there is a line to be drawn somewhere- right? And do your best to ignore the mutterings.

About that time Ryan dropped the lazarette hatch on his foot. This thing weighs about 25 pounds and I know it can hurt you as I have dropped it on my head and back. Luckily he just had a pretty good gash and some torn toenails and bruises. It could have been a lot worse. But he still got out of working. I asked him if it was worth it!

Shelly panicked a bit and had visions of missing toes and stuff.

We are very happy to back out on the water.

Harbortown HHI lighthouse

It was a very nice motorsail over to Daufuskie Island SC to drop the hook for the night. Then over to Harbortown Marina at Sea Pines in Hilton Head Island the next morning for fuel in the place Shelly and I got married 30 years ago!

Yesterday we pounded into a 20 knot breeze across Port Royal Sound over to Beaufort and we are anchored off Port Royal Marina.

This next week will be spent putting together a golf tournament fundraiser for paws4people/paws4vets for late April 2016. Anyone want to help?  It will be a lot of fun.

Thanks for all the comments and responses from the last email. We like hearing from you!

Goose says Hi!